Philips AZ1138/00 User Manual page 10

MP3-CD/ CD-Player
– During playback: elapsed playback
time of current track and current track
number
– Pause: elapsed playback time freezes
and flashes
– /
SHUFFLE REPEAT
respective mode is activated
– : when MP3 CD/ CD
PROGRAM
programme active; P ro g also appears
briefly when you store a track
– no SEL: programme activated but no
tracks selected
– FULL: programme memory full
– no P ro g: programme cancelled
– Cd Err, no d1SC or nF d1SC:
error in CD operation/ no disc/ or a
CD-R(W) is blank or the disc is not
finalised (see Troubleshooting)
MP3-CD/ CD Playback
This unit can play:
- all pre-recorded audio CDs
- all finalised audio CDR(W)s
- MP3-CDs (CD-ROMs with MP3 files)
1 Adjust the POWER slider to CD.
Display: shows Cd briefly.
2 To open the CD door, lift the CD door at
the edge marked LIFT TO OPEN.
3 Insert a disc with the printed side facing up
and press the CD door gently close.
4 Press PLAY•PAUSE 2; on the set to
start playback.
10
modes: when the
5 To pause playback press
PLAY•PAUSE 2;.To resume, press
PLAY•PAUSE 2; again.
The elapsed playback time freezes and
flashes.
6 To stop playback, press STOP 9.
7 To switch off the set, adjust the POWER
slider to TAPE/
the cassette keys are released.
Note: playback will also stop when:
– you open the CD compartment;
– you select RADIO or TAPE sound
source;
– the disc has reached to the end.
Selecting a different track
During playback you can use the
TRACK•SEARCH ∞ , § or
TRACK +/–10 PRESET 3, 4 to select a
particular track.
• If you have selected a track number in the
stop or pause position, press
PLAY•PAUSE 2; to start playback.
• Press TRACK•SEARCH § once briefly
for the next track, or press repeatedly until
the desired track number appears in the
display.
position and check
OFF