Download Print this page

StonePoint WWL4-6600N Installation Instructions

6600 lumen led weatherproof 4 ft. ceiling light

Advertisement

Quick Links

6600 Lumen LED
Weatherproof 4 ft.
Ceiling Light
PACKAGE CONTENTS
16" Insulated
Direct Wire Cord
2x Medium
Screws
2x Wall
Anchors
Electrical requirements can be found on fixture.
Use with a minimum 90° C supply conductors.
BACK
48 in.
122 cm
SIDE
Product Facts:
Color Temperature: 4000K
2x Mounting
Lumens: 6600 LM
Clips
Lumen Efficacy: 143
Input Voltage: AC120/60Hz
Rated Watts: 46W
CRI: 80
Power Factor: 0.9
LED Beam Angle: 120°
LED Emitter Life: 50,000 hours
Operating Voltage: 100-277v
Operating Temperature: -4° to 122°F (-20° to 50° C)
Cord: 18/2 SJT
Cord Length:1.5 ft
This fixture is IP66 rated and therefore is suitable for wet
location indoor /outdoor use.
1
MODEL No: WWL4-6600N
Mounting Clip Track
Diffuser
2.9 in.
7,3 cm
1.69 in.
4,3 cm

Advertisement

loading
Need help?

Need help?

Do you have a question about the WWL4-6600N and is the answer not in the manual?

Questions and answers

Summary of Contents for StonePoint WWL4-6600N

  • Page 1 MODEL No: WWL4-6600N 6600 Lumen LED Weatherproof 4 ft. Ceiling Light PACKAGE CONTENTS BACK 2.9 in. 7,3 cm Mounting Clip Track 16” Insulated Direct Wire Cord 48 in. 122 cm 1.69 in. 4,3 cm SIDE Diffuser Product Facts: Color Temperature: 4000K...
  • Page 2 WARNINGS CAUTION: Personal injury can occur, along with damage WARNING: This product needs to be grounded properly in a to the fixture and/or mounting surface may result if the manner consistent with local electrical codes and/or the fixture is pulled from the surface. To prevent premature failure current National Electric Code (NEC).
  • Page 3 INSTALLATION (CONTINUED) 1. Each mounting clip attaches approximately 4 inches from each end of the fixture on the mounting clip track (Fig. 2). Locate where each mounting clip will be mounted and mark the location on the mounting surface (Fig. 3). 4”...
  • Page 4 INSTALLATION (CONTINUED) 3. Your installation is now complete (Fig. 14). Restore the power. Fig. 14 CLEANING INSTRUCTIONS Disconnect power to fixture before cleaning. Using a soft cloth, clean the fixture using a mild, non-abrasive glass cleaner. DO NOT use solvents. DO NOT use cleaners containing abrasive agents. NEVER spray liquid cleaner directly onto the LEDs, fixture or wiring.