Installation (Between Joists Mounting) - Panasonic FV-08VRE1 Installation Instructions Manual

INSTALLATION (BETWEEN JOISTS MOUNTING)

Please follow the installation steps as below:
1. Insert the suspension brackets into the fan body
from each side of the bracket cover. (Fig. 1)
If spacing A between center joists is 12 inches,
cut all suspension brackets along the two "C"
cuts with a hacksaw or other tools.
2. Fix suspension brackets and
(ST4.2X6), but remember not to tighten the screws
up yet. (Except that the spacing is 12 inches between
joists.) (Fig. 1)
3. Position the fan body between joists, and hold it
properly. Mark the long holes of all the four
suspension brackets on joists. (Fig. 2)
4. Fix four long screws (ST4.2X20) partially into joists
at the four marked locations. (Fig. 3)
6
Adaptor
Tape
Damper
2-"C" cuts
with screws
Unit: inches (mm)
Adaptor
Joist
Suspension
bracket
Before
Ceiling
Unit: inches (mm)
After
Screw
(ST4.2X6)
Long hole
UP
Fan body
Joist
>1/8 (3.2)
4-Long screws
(ST4.2X20)
joists
Suspension
bracket
Suspension
bracket
Bracket cover
Fig. 1
Suspension
bracket
Fig. 2
Fig. 3 Fig. 3