TDK DVW-A020106 Manual page 27

Figure 9: Jumper setting for CS-supported TDK DVD-R/RW writer configuration.
CS SL MA
reserved
TDK DVD-R/RW writer's correct
CABLE SELECT* jumper setting
for CS-supported writer
configuration.
If your computer lacks an empty drive* bay, remove the existing IDE* CD-ROM drive and
install the TDK DVD-R/RW writer in its place.
You will need to make a minimum of two cable connections to install your TDK DVD-R/RW
writer:
• the IDE* cable and • the power cable
A third cable connection will need to be made if your computer features a soundcard* and you
plan to connect the TDK DVD-R/RW writer's audio output to the soundcard's* audio connector
for audio playback using non-TDK software.
Do you need another IDE* flat-ribbon cable?
The IDE* cable is a standard 40-pin flat-ribbon cable, along the length of which there are usually
three connectors. One end connects to the IDE* port* on your computer's motherboard* and
the other two connectors are free for attaching internal peripherals such as a hard disk* or CD-
ROM drive. If you need another IDE* ribbon cable, you can use the extra IDE* cable supplied
with your TDK DVD-R/RW writer.
Figure 10: Internal IDE* 40-pin ribbon cable
To PIN #1
27