Configuring Packetsmart Through The Cli - AudioCodes MediaPack 20 Series Quick Manual

4.2

Configuring PacketSmart through the CLI

You can alternatively configure PacketSmart through the device's Command Line Interface
(CLI).

To configure PacketSmart through the CLI:
1. Open a Telnet connection to the MP-20x device (Default: telnet 192.168.2.1)
2. Log in with administrator privileges (Default: admin/admin)
3. Run the following commands under the MP20x> prompt:
conf set "packetsmart/enabled" "1";
conf set "packetsmart/packetsmart_server_ip" "<URL>"
conf set "packetsmart/packetsmart_server_port" <Port>
conf set "packetsmart/configuration_upgrade_server_ip" "<URL>"
conf set "packetsmart/configuration_upgrade_server_port"
<Port>
conf set "packetsmart/load_server_ip" "<URL>"
conf set "packetsmart/load_server_port" <Port>
conf set "packetsmart/configuration_upgrade_server_url"
"<URL>"
conf set "packetsmart/monitor_interface" "eth1"
conf set "packetsmart/network_interface" "br0"
conf reconf 1
Quick Guide 18
PacketSmart Monitoring
Document #: LTRT-25313