Technical Data; Order Information - Marmitek SW10 Quick Start Manual

Shutter switch, in-wall, on/off/dim

User manual (28 pages)

page of 2

/ 2
Bookmarks

SW10

The X-10 wall mounted motor drive switch is a receiver module that is controlled by any X-10 controller. It can be used for curtains, sun shades and shutters. The most common ap-

plication is shutter control.

The unit controls the position of a shutter or a blind either in response to X-10 signals received on the powerline or manually from pushbuttons on the front face of the unit.

If the serial control message is in STANDARD X-10 format, the unit can be:

• Fully opened in response to "unit code" "On"

• Fully closed in response to "unit code" "Off"

• Opens in response to "unit code" "Bright"

• Closes in response to "unit code" "Dim"

Each "Dim" or "Bright" message will move the motor by 4% of the opening. If the message is in Extended X-10 format, then any position can be possible with a single message.

The unit is currently supplied with cover plate Jung CD 500 and mounting frame.

Typical applications:

Make your house look "lived-in" when you are away with presence simulation of your shutters or curtains. When going out, one button controls all shutters.

Can also be used as an ordinary switch.