Table of Contents
Advertisement
Quick Links
Kinetic Log Splitter
Owner's Manual
IMPORTANT
Please read these instructions carefully before assembly, to
reduce risk of fire, burn hazard or other injury.
Keep these instructions in a safe place for future use.
This manual covers a the Masport Kinetic Log Splitter
www.masport.com
Part N
: 548887.A.3
o
Advertisement
Table of Contents
Summary of Contents for Masport SK-E5T
- Page 1 Please read these instructions carefully before assembly, to reduce risk of fire, burn hazard or other injury. Keep these instructions in a safe place for future use. This manual covers a the Masport Kinetic Log Splitter www.masport.com Part N : 548887.A.3...
-
Page 3: Table Of Contents
CONTENTS CONTENTS SAFETY INSTRUCTIONS WARNING LABELS ......................................4 GENERAL SAFETY ......................................4 A NOTE TO ALL USERS ....................................5 SETTING UP THE LOG SPLITTER KINETIC LOG SPLITTER CONTROLS AND FEATURES ..........................6 ASSEMBLY INSTRUCTIONS OPERATION STOPPING THE MOTOR ....................................8 SPLITTING LOGS ...................................... -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS Keep children and pets at least 50 feet from the working area and ensure they are under the watchful care of a responsible adult. Be alert and turn the machine off if children or pets enter the work WARNING! area. -
Page 5: A Note To All Users
• Check the condition of the power cable by regularly for insulation damage, replacing if necessary. IMPORTANT! If the moulded 3 pin plug attached to this unit is damaged and needs replacing, it is important that it is correctly destroyed and replaced by an approved BS 1363/13A fused plug and that the following wiring instructions are followed. -
Page 6: Setting Up The Log Splitter
KINETIC LOG SPLITTER CONTROLS AND FEATURES Fig.1 Safety Level Engagement Handle Belt Guard Splitting Wedge Handle Cradle Belt Frame stand Flywheel MODEL SK-E5T SK-E8T Motor 1500W,240V~50Hz 1600W, 240V-50Hz Max Splitting force 5ton 8ton Max splitting length 400mm 520mm Max splitting dia. -
Page 7: Assembly Instructions
ASSEMBLY INSTRUCTIONS STEP 4 The log splitter will require some assembly, please follow the below Slide the log splitter towards the back, allowing the log splitter to overhang assembly instructions. It is recommended two people assembly the log the packing crate base, remove the polystyrene from the behind the front splitter as it is heavy and whilst you do not have to lift the log splitter support stand and place under the frame at the back of the log splitter directly, some support may be required as you slide the log splitter on the... -
Page 8: Operation
OPERATION STARTING THE MOTOR Position your Log Splitter on a flat, dry surface and chock the Wheels Stand to prevent the Splitter from moving during use. Make sure the Log Splitter is plugged into a properly grounded protected outlet. Push the green button (Fig. 2). Fig.4 ON/OFF Switch Fig.2... -
Page 9: Splitting Tough Logs
of the Log Splitter, making sure that one end is against the Splitting Top of rail Wedge. WARNING! The engagement Handle must be held fully in the Split Position against the hard stop when splitting. Failure to do so may result in kickback of the Handle. Fig.8 1 Safety Lever LUBRICATION... -
Page 10: Troubleshooting
TROUBLESHOOTING Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their solutions. If you continue to experience problems, contact your local dealer. WARNING! Before performing any maintenance procedure or inspection, stop the electric motor, wait five minutes to allow all parts to cool. Disconnect the power cord from the source of Electricity. - Page 12 Masport Limited 1-37 Mt Wellington Highway Panmure Auckland 1060 New Zealand P: 0800 627 767 (New Zealand) P: 1300 366 225 (Australia) Copyright © 2019 Masport Limited...