Assembly Instructions - Masport SK-E5T Owner's Manual

ASSEMBLY INSTRUCTIONS

The log splitter will require some assembly, please follow the below
assembly instructions. It is recommended two people assembly the log
splitter as it is heavy and whilst you do not have to lift the log splitter
directly, some support may be required as you slide the log splitter on the
base.
STEP 1
Undo the metal tabs at the base of packing crate.
This can be safely done with a small hammer and flat screwdriver.
STEP 2
Carefully open the plywood case and unwrap the contents.
Please dispose of the packing using recycling methods wherever possible.
STEP 3
Using the screws provided, attach the front support stand.
STEP 4
Slide the log splitter towards the back, allowing the log splitter to overhang
the packing crate base, remove the polystyrene from the behind the front
support stand and place under the frame at the back of the log splitter
and attach the rear wheels using the fasteners provided. This part of the
assembly is easier to achieve if are two people are present.
STEP 5
Using the front handle, carefully raise the log splitter until the rear wheels
touch the ground, remove the polystyrene and packing crate base from
under the frame and the log splitter will now be portable. Undo any
electric cable ties and familiarise yourself with the safety decals of the Log
Splitter. Read and follow the instructions in the Owner's Manual regarding
safe usage of this Log splitter before operating.
The log splitter is now ready to use.
NOTE:
Please take precautions to avoid any possible injury during the unpacking
and assembly of this product.
7