Assembly And Positioning; Fitting The Castors - Dimplex OCR15 Manual

may result in melting, distortion and even the
risk of fire!
This instruction leaflet belongs to the appliance
and must be kept in a safe place. If changing
owners, the leaflet must be surrendered to the
new owner.
DO ENSURE that the mains lead cannot be
tripped over.
DO NOT operate the radiator with the mains lead
overhanging the fins.
The heater must be on a flat stable surface when
in use.
If the radiator is tipped over, unplug it and allow
it to cool before standing it back up
DO NOT pull the radiator along by the mains lead.
The supply cord should be uncoiled before use.
ELECTRICAL CONNECTION
WARNING THIS APPLIANCE MUST BE EARTHED
If the socket outlets in your home are not of the 13 amp BS1363
type they will not accept the plug connected to this heater,
therefore cut off the plug. When cut off this plug can constitute
a shock hazard if inserted into a socket outlet. It must therefore
be disposed of safely.
IMPORTANT: The wires in this mains lead are coloured in
accordance with the following code:
BLUE:
BROWN:
GREEN & YELLOW:
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows:
Connect the BROWN wire to the terminal marked 'L' or
coloured RED. Connect the BLUE wire to the terminal marked
'N' or coloured BLACK. Note: 'L' or 'N' must not be connected
to the EARTH terminal marked 'E' or ' ' or coloured GREEN
or GREEN AND YELLOW. If in doubt, consult your electrician.

Assembly and Positioning

FITTING THE CASTORS

WARNING The radiator must only be operated
with the wheels and castors fitted and in the
upright position.
NEUTRAL
LIVE
EARTH
The castors must be fitted to the control panel and
between the last and second last fin on the opposite
end, as shown in Fig.1.
To fit the castors, turn the radiator upside down on a
carpet or other soft surface to avoid damage
WARNING : THE RADIATOR IS HEAVY – ENSURE
THAT IT IS SUPPORTED TO PREVENT IT FROM
TOPPLING. Ask a second person to help with this if
necessary.
Locate the wire clamp (A) and remove the winged
nut (C). Insert the non threaded end of the wire clamp
into one of the holes in the castor plate (B) as shown.
Feed the threaded end of the wire clamp between
the last and second last column fins ensuring the wire
clamp wraps around the column body (sump). some
manipulation of the plate and clamp will be required.
The threaded end should then be passed through the
castor plate and secured using the wing nut.
To fit the castor to the control end, position the castor
plate in position and secure using the wing bolts (D).
there are guides to ensure the correct positioning and
orientation of the caster plate.
Return the radiator to the correct orientation so it rests
on the castors. The product is now ready for use.
C
B
A
D
Fig. 1