Toro TX 427 Series Operator's Manual page 11

115-4862
1. Loader-valve
lock—unlocked
1. Warning—read the Operator's Manual.
2. Warning—set the parking brake, shut off the engine, remove the ignition key and lower the loader arms before leaving the machine.
3. Crushing hazard—install the cylinder lock and read the instructions before servicing or performing maintenance.
4. Cutting hazard of hands or feet—wait for all moving parts to stop; stay away from moving parts; keep all guards and shields in
place.
5. Crushing/dismemberment hazard of bystanders—keep bystanders a safe distance away from the machine.
6. Explosion and electric shock hazard—do not dig in areas with buried gas or electrical lines; contact local power organizations
before digging.
1. Read the Operator's Manual, located
inside the rear-access cover.
2. Fast
3. Continuous-variable setting
4. Slow
5. Throttle
6. On
2. Loader-valve lock—locked
7. Choke
8. Off
9. Fuel
10. Hydraulic-fluid temperature
11. Hour meter
12. Engine—start
115-4860
117-4045
11
13. Engine—run
14. Engine—shut off
15. Warning—do not operate this machine
unless you are trained.
16. Electric shock hazard, overhead power
lines—stay away from overhead power
lines.
17. Tipping hazard—move the traction
unit with the heavy end up hill; carry
loads low; never jerk the controls; use
a steady, even motion.
18. Tipping hazard—slow the traction unit
when turning, do not travel fast when
turning, look behind and down when
reversing.