Sleep Timer Setting - Philips FW-C780/25 User Manual

Clock/Timer
2
Press CD, TUNER or TAPE to select the
desired source.
Before setting the timer, make sure the music
source has been prepared.
CD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK•TIMER to store the start time.
"TIMER ON" will be displayed and followed
by the set timer "XX:XX" and then the selected
source.
will remain on the display.
TIMER
At the preset time, the selected source will play.
To exit without storing the setting
Press Çon the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
Press TIMER ON/OFF on the remote control.
The display will show "CANCEL" and
will disappear from the display.
To activate the TIMER
Press TIMER ON/OFF on the remote control.
The last set timer information will be shown
for a few seconds and
the display.
24
pg 001-027/C720-C780/21-Eng
TIMER
will appear on
TIMER
24

Sleep Timer Setting

The sleep timer enables the system to switch to
Standby mode automatically within a preset
amount of time.
1
Press SLEEP on the remote control repeatedly
to select a preset amount of time.
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 ...
"SLEEP XX" or "OFF" will be displayed. "XX"
is the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
will appear on the display, except for
SLEEP
"OFF" mode.
The Sleep Timer is now set. Before the
system switches to standby mode, a countdown
of 10 seconds will be displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™ "SLEEP"
While SLEEP mode is activated
To check the remaining length of time
Press SLEEP once.
To change the preset sleep timer
Press SLEEP twice.
The display will show the remaining time
followed by the sequence of sleep timer options.
To deactivate the Sleep Timer
Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
6/8/01, 8:45 AM
3139 115 20592