Table of Contents
Advertisement
Leveling Instructions
The unit must have all bottom corners resting
firmly on a solid floor. The floor must be strong
enough to support a fully loaded appliance.
NOTE
It is Very Important for your appliance to
be level in order to function properly. If
the unit is not leveled during installation,
the door may be misaligned and not close
or seal properly, causing cooling, frost, or
moisture problems.
To Level The Refrigerator:
While unit is lying on its back, note the loca-
tion of the 4 leg levelers installed at each
corner. These leg levelers will be used to
level the appliance and to adjust the height.
Use a carpenter's level to level the unit
from front to back and side to side. Adjust
the plastic leveling feet in front, ½ bubble
higher, so that the door closes easily when
left halfway open.
NOTE
Make sure to allow space for the Trim and
Leveling Kit (TRIMKITSS1 or TRIMKITSS2)
if it is to be installed with the unit.
Leveling Instructions For Matching Refrig-
erator/Freezer Pair:
• Level door of first unit using all 4 level-
ers and slide unit into place. Recheck for
levelness and adjust if necessary.
• Measure distance from floor to bottom of
door on first unit. Adjust and level second
unit so door height matches.
Leg Level Adjustments:
• One full turn of all 4 leg levelers will raise
door
/
".
5
32
• Slide second unit into place leaving a
minimum gap of
door swing clearance.
• To make the final adjustment, it may be
necessary to pull one of the units out to be
able to access the rear levelers.
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to fine tune
the door alignment. Use a
wrench to adjust the screw at the bottom of
the lower hinge.
Adjusting Doors For Matching
Refrigerator/Tall Freezer Pair
The doors may also be adjusted side to side
with the slotted hinge for aligning the doors
parallel to each other. Loosen the 3 screws
with a ⅜" wrench. Shift the doors until par-
allel, and then retighten the screws securely..
(See illustration below.)
Lower Hinge Adjustment For
Leveling The Doors Of The Matching
Refrigerator/Freezer Pair
To level the doors using the adjustable lower
hinge (some models):
1.
If the refrigerator door is lower than
the freezer door, raise the refrigerator
door by turning the adjustment screw
clockwise using a
(See illustration below.)
2.
If the freezer door is lower than the
refrigerator door, raise the freezer
door by turning the adjustment screw
clockwise using a
(See illustration below.)
Door
Raise
Door
Freezer
7
/
" between units for
3
16
/
" socket or
7
16
/
" socket wrench.
7
16
/
" socket wrench.
7
16
Freezer Hinge
Adjustment
Door
⅜" Hex Drive
Screw
Raise
Door
Refrigerator
Advertisement
Table of Contents
