Leveling Instructions - Kenmore 253.4474 Use & Care Manual

Leveling instructions
Leveling
The refrigerator must have all bottom corners resting firmly
on a solid floor.
The floor
must be strong enough to support a
fully
loaded
refrigerator.
It is VERY IMPORTANT for your refrigerator to be level in
order to function properly. If the refrigerator is not leveled
during instailation_ the door may be misaligned and not
close or seal properly, causing cooling, frost or moisture
problems.
To Level The Refrigerator:
While unit is lying on its back for wood skid removal_
note the location of the four (4) leg levelers installed at
each corner. These leg levelers will be used to level the
refrigerator and to adjust the height. Use a carpenter's
level to level the refrigerator from front to back and side
to side.
NOTE
Make sure to allow for the Trim and Leveling Kit if it is to
be installed with the unit.
Plastic
Leveling Feet
Crating
Screw
',,,
_J
Discard The (4)
Crating Screws
And Wood Bases
Leveling Instructlons For Matching Refrlgerator/Freezer Pair:
* Level door of first unit using all four levelers and slide unit
into place. Recheck for levelness and adjust if necessary.
° Measure distance from floor to bottom of door on first
unit. Adjust and level second unit so door height matches.
Leg Level Adjustments:
" One full turn of all four leg levelers will raise door 5/32".
° Slide second unit into place leaving a minimum gap of
3/16" between units for door swing clearance.
° To make the final adjustment_ it may be necessary to pull
one of the units out to be able to access the rear levelers.
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to fine tune the door
alignment. Use a 7/16" socket or wrench to adjust the
screw at the bottom of the lower hinge.
Adjusting Doors For Matching Refrigerator/
Tall Freezer Pair
The doors may also be adjusted side to side with the
slotted hinge for aligning the doors parallel to each other.
Loosen the two baits with a 3/8" wrench and one screw
with a Phillips screwdriver. Shift the doors until parallel_
then retighten the screws securely. (See illustration below.)
Lower Hinge Adjustment For Leveling The Doors
Of The Matching Refrigerator/Freezer Pair
To level the doors using the adjustable lower hinge (some
models):
1. If the refrigerator door is lower than the freezer door_
raise the refrigerator door by turning the adjustment
screw clockwise using a 7/16 inch socket wrench.
(See illustration
below.)
2. If
the freezer door is lower than the refrigerator
door_ raise the freezer door by turning the adjustment
screw clockwise using a 7/16 inch socket wrench.
(See illustration below.)
Freezer Refrk