Cleaning And Maintenance - Klarstein 10032527 Manual

EN
24
Safety cutout system
This product has one non-self-resetting overheat protection device (thermal cut-out)
which will activate if the air inlets or outlets are obstructed. For safety reasons the fire will
NOT switch on again automatically, the following procedure must be carried out before
the fire can be operated.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a period
of no less than 10 minutes, ensuring all obstructions are removed. Switch the appliance
ON at the wall. Ensure the appliance is turned ON at the control switches. If the fire
fails to operate correctly, repeat the above procedure. If an attempt to switch on the
appliance is made before the safety cutout has reset, the appliance may cutout for a
further period of time. If the sequence has been followed correctly and the appliance still
fails to function, check the fuse in the wall outlet. If this is not the cause, call an electrician
or maintenance engineer.
Note: The visual effect will remain operational if the cutout is activated, only the fan
heater is prevented from working.

CLEANING AND MAINTENANCE

Note: always disconnect the appliance at the supply outlet socket before undertaking
any cleaning.
• Except for periodic cleaning of dust, there are no specific requirements for care,
other than regular cleaning of the general appliance. A wipe with a dry cloth is
normally sufficient. DO NOT use abrasive cleaners as they can damage the finish.
• Make sure the heater outlet grille (located next to the switches) are kept clear
of dust, pet hair and other airborne household matter. These should be vacuum
cleaned periodically using a brush attachment.
• If in doubt consult a qualified electrician.
• Excluding fuses, use only genuine manufacturers spare parts available from your
supplier.