Table of Contents
Advertisement
3.2
Changing/Reading APPKEY
This section details the steps needed to change APPKEY/APPDEUI and how to read
APPKEY/APPDEUI/DEVEUI.
Before you start, make sure you have a classic serial software installed on your
computer. We recommend using Docklight V2.2 or a similar program. Parameters are:
Baudrate: 9600
Parity: None
Data bits: 8
Stop bits: 1
A UART to USB connector is required to connect the AIOT-ILND01 to your computer.
Connect the adapter to the AIOT-ILND01 by attaching a 4-pin GROVE cable to the
middle GROVE connector (CN12). The AIOT-ILND01 must be powered to change
parameters. See the figure below for an example setup.
Chapter 3 – Motor Setup
18
Advertisement
Table of Contents
