Marquis Vector21 Series Owner's Manual page 33

MICROSILK OPERATING INSTRUCTIONS (OPTIONAL)
®
• Press the "Start" button on the MicroSilk
the master control panel to turn on the feature.
a. The pump will start and you will notice the presence of the
micro-bubbles beginning to enter the water from two fittings in
the footwell. Do not block theses fittings during operation. Periodic
bursts of air are normal and will not affect operation or effectiveness.
b. It can take up to 8 minutes depending on the size of model to
completely fill the water with micro-bubbles. You will notice the
water will change from clear to milky in appearance.
c. If any of the other therapy pumps are on, they will be turned off
automatically after pressing the start button and may take up to
30 seconds for pumps to turn off. This is necessary for the proper
concentration of micro bubbles to be generated.
• The MicroSilk pump will run for 20 minutes and then automatically turn
®
off. If continued operation is desired, pressing the "Start" button will
restart the system for another 20 minutes.
a. Please note: Periods longer than 20 minutes in elevated
temperature may be harmful to your health. Please refer to the
safety instructions in the Owner's Manual.
• To manually turn the feature off, simply press the "Start" button a
second time to turn off.
• A clean-up cycle will automatically turn on the filtration pump 30 minutes
after using the feature.
Maintenance Considerations
• Due to the nature of how MicroSilk
notice higher levels of body oils than normal. This can also be increased
if multiple bathers are using the feature at the same time or more
frequently. As a result, setting the controls to perform longer filtration or
clean-up cycles may be necessary. Please refer to the instructions in
the Owner's Manual to make a change to the duration of the filtration or
clean-up cycle.
• It is recommended to clean the filter cartridge/s once per month or
twice a month if you are frequently using this feature to exfoliate, to
ensure they are free from debris and oils. Failure to do so may result in
poor water quality or the ability to properly clean up the water after use.
• It may be necessary to increase the setting on the bromine or chlorine
cartridge located in the in-line sanitation housing or increase the amount
of other sanitizer you may be using. Checking the sanitizer regularly and
adjusting as needed is very important to water safety.
VECTOR21 SPA CONTROL OPERATION
panel that is located next to
®
works to exfoliate the skin, you may
®
33