Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The; Step 2: Setting The Clock - Philips MCD295/12 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
3
Close the cover.

Using the remote control to operate the

system
1
Point the remote control directly
at the remote sensor (iR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
DISC, TUNER).
3
Then select the desired function
(for example 2;, í, ë).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

1
Go to Standby mode.
2
Press and hold CLOCK/RDS on the front
panel.
➜ "SET CLOCK" is displayed briefly. Then, the
hour digits flash on the display screen.
3
Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the hours.
4
Press CLOCK/RDS again.
➜
The minute digits flash on the display screen.
5
Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the minutes.
6
Press CLOCK/RDS to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Preparations
19