Advertisement
Outdoor Alerting System Strobe
Powering the Strobe
Whether one strobe or two is installed, only one power cable needs to be used.
1. Once again, locate the short gray cable that connects the first strobe to the informer. There is a black
cable also attached to this connection. Attach the male end of the black cable to the female connection
on the power supply provided.
2. Connect the pronged end of the power supply into an electrical outlet.
If assistance is needed at any point during the setup or operation of the Earth Networks Outdoor Alerting
System Strobe, please call Earth Networks Technical Support at 800‐624‐4205 or email
support@earthnetworks.com
WARRANTY The Seller warrants the hardware purchased by the Buyer against defects in workmanship
and materials for a period of one (1) year from date of delivery under this contract. The Seller shall,
at its sole option, either repair or replace defective items. Buyer is responsible to return of defective
items to Seller by means specified by the Seller. The Buyer shall bear all shipping expenses.
Packing of defective items for return is responsibility of Buyer. Damage due to natural causes (storms,
lightning, flying debris, etc.) is not covered by this warranty. Damage resulting from Buyer negligence or
mishandling of hardware and software is not covered by this warranty.
EN.PM.UM76 2017022323
for further assistance.
Earth Networks
Page 7 of 7
Advertisement
