Advertisement
Outdoor Alerting System Strobe
Getting Started
Before beginning, disconnect the informer power from the electrical outlet.
Installing the strobe to the informer
For installing either one strobe or two strobes , this first portion needs to be completed. The cables provided
will be needed as well as a small screw driver for the bare wire connection points. A short gray connection
cable (exposed wire on one side and a green connector on the other side) is provided as well as the 100 ft gray
cable (a green connection on one end and the strobe on the opposite end.) The wires will need to be guided
through the wall and/or ceiling, depending on placement desired, before these steps are completed.
1. Start by connecting the 8 inch grey cable and the informer. Use the last two ports on the informer
connection. If you have a complete horn system the other ports will be occupied like below.
2. Place the red and black exposed wires into each port and tighten the screws on the connection to lock
the wires in place. The order of red and black does not matter for this side.
EN.PM.UM76 2017022323
Earth Networks
Page 2 of 7
Advertisement
