Setting the clock
1
In standby mode or system on, press and hold
DISPLAY/CLOCK on the remote control for
more than 3 seconds.
➜
SET CLOCK scrolls on the display.
➜
The clock digits for the hours flash.
2
Press VOLUME (3 / 4) (+/-) to set the hours.
3
Press DISPLAY/CLOCK again.
➜
The clock digits for the minutes flash.
4
Press VOLUME (3 / 4) (+/-) to set the
minutes.
5
Press DISPLAY/CLOCK to confirm the time.
Note:
– The backlight for clock display is dim in standby.
Viewing the clock
●
Press DISPLAY/CLOCK.
➜
The clock time is displayed.
Note:
– There is no time display during disc playback.
Setting the timer
●
The system can be used as an alarm clock,
whereby the CD, TUNER is switched on at a set
time. The clock time needs to be set first before
the timer can be used.
●
During setting, if no button is pressed within 30
seconds, the system will exit timer setting mode
automatically.
16
1
In standby mode or system on, press and hold
TIMER on the remote control for more than 3
seconds.
➜
Display sequence scrolls SET TIMER and
SELECT SOURCE.
➜
Display sequence shows CD, TUNER and
flashes.
2
Press VOLUME (3 / 4) (+/-) to select the
sound source.
3
Press TIMER to confirm your desired mode.
➜
The clock digits for the hours flash.
4
Press VOLUME (3 / 4) (+/-) to set the hours.
5
Press TIMER again.
➜
The clock digits for the minutes flash.
6
Press VOLUME (3 / 4) (+/-) to set the
minutes.
7
Press TIMER to confirm the time.
➜
Display sequence shows VOL12.
8
Press VOLUME (3 / 4) (+/-) to set the timer
volume level.
9
Press TIMER to confirm.
➜
The timer is now set and activated.
Activating and deactivating
TIMER
●
Press TIMER on the remote to turn off the
timer or turn on to the last setting again.
➜
If activated, the timer information will display
for a few seconds, then the system resumes to
the last active source or stays in standby mode.
➜
If deactivated, "OFF" appears.
Note:
– The system will exit timer setting mode if no
button is pressed within 30 seconds.
Clock/Timer