Table of Contents
Advertisement
1. Left rear-lift chain
Leveling Side to Side
If the cut is uneven across the mower swath, correct it
as follows:
1.
Park the machine on a level surface on the shop
floor.
2.
Set the cutting unit to the desired height of cut,
move the throttle lever to the S
shut off the engine, engage the parking brake,
and remove the key.
3.
Check and adjust front and rear tractor tire
pressure; refer to the traction unit Operator's
Manual.
4.
Check for bent blades.
5.
Remove the covers from the top of the cutting
units.
6.
Rotate the blade on each spindle until the ends
face forward and backward.
7.
Measure from the floor to the front tip of the
cutting edge.
8.
Adjust the jam nuts securing the deck chains to
the mower deck until the mower deck is level
(Figure
11).
Figure 11
2. Right rear-lift chain
position,
LOW
Operating Tips
Folding the Caster Arm
To gain access to or from the operator area when the
wing decks are folded up, release the caster arm latch
(Figure
12) and rotate the caster arm away from the
traction unit.
g025273
1. Caster-arm latch
Important:
Rotate the caster arm back to the
machine before mowing.
Using the Transport Latches
Before transporting the machine, raise the wing decks
and secure the wing deck transport latches
13).
1.
Wing deck transport latches
11
Figure 12
(Figure
Figure 13
g025274
g025275
Advertisement
Table of Contents
