Power Off; Display Setting; Network Setting - Jands SNVR-8004ST User Manual

3.4 Power off

1. Click the power switch at the rear panel can shutdown the device.
2. 【Main Menu】  【Power Off】 ， select 【Yes】 (By this way, user need have shutdown authority)
(Suggest to shutdown device in this way, it can avoid damaging the device from v electricity
cut-off by accident).
Note: Before changing the HDD operation, please shutdown the device and cut the power supply
first.

4. Display Setting

Click 【Display】 on the menubar，
show the menu as the right side:
1) Language: select different language according to the
necessary, after that need restart the device
AutoLogout: system automatic logout and lock time.
2)
3) TV Adjust: adjust the display position.
4) Display: set monitor lightness, contrast, saturation,
color
5) Resolution: the default resolution is 1024x768,
please select the best resolution according the monitor
condition, or it will affect the image definition.
There are 6 modes for option.
6) Rotation interval:

5. Network Setting

Connect NVR with network cable to LAN switch.
After power on, click 【Network】 on the menubar
to enter setting menu, set NVR IP address, subnet
mask, and gateway and so on. Then use PC to run
ping command to check NVR IP has connected
with LAN
Note: IP address might conflict with each other, please set the gateway correctly, or NVR might
fail to work. Please ensure all the IP addresses in LAN are unique.
Setup the time interval of rotation. Tick "Enable SEQ" to start rotation.
- 3 -