J7: Power Connector; Dc Power Details - Dalsa Xtium-CLHS PX8 User Manual

The Sync Slave Xtium board is configured to receive its trigger on the board sync signal. As

an example the following image shows the Xtium board configured for an external sync on
board sync #2.
Test Setup: Start the acquisition on all slave boards. The acquisition process is now waiting for

the control signal from the master board. Trigger master board acquisition and the acquisition
start signal is sent to each slave board.

J7: Power Connector

DC Power Details

Warning: Never remove or install any hardware component with the computer power on.
Never connect a power cable to J7 when the computer is powered on.
Connect a computer 6-pin PCI Express power connector to J7 to supply DC power to connector
•
J1/J4. Older computers may need a power cable adapter (see Power Cable Assembly OR-YXCC-
PWRY00).
Xtium-CLHS PX8 User's Manual
Technical Specifications • 77