J7: Power Connector - Dalsa Xtium-CL PX4 User Manual

The Sync Slave Xtium board is configured to receive its trigger on the board sync signal. As

an example the following image shows the Xtium board configured for an external sync on
board sync #2.
Test Setup: Start the acquisition on all slave boards. The acquisition process is now waiting for

the control signal from the master board. Trigger master board acquisition and the acquisition
start signal is sent to each slave board.

J7: Power Connector

DC Power Details
Warning: Never remove or install any hardware component with the computer power on.
Never connect a power cable to J7 when the computer is powered on.
Connect a computer 6-pin PCI Express power connector to J7 to supply DC power to the
•
Camera Link connectors for PoCL operation and/or to supply power to connector J1. Older
computers may need a power cable adapter (see Power Cable Assembly OR-YXCC-PWRY00).
The 12 Volt can supply up to 8W of power to the cameras (4W per connector) and 6W to J1.
•
Note that J1 has a 500 mA re-settable fuse on the board. If the fuse trips open, turn off the
host computer power. When the computer is powered again, the fuse is automatically reset.
78 • Technical Specifications
Xtium-CL PX4 User's Manual