Advertisement
Table of Contents
INSTALLATION GUIDE
PACIFIC LAMP MODULE COVER KIT
IMPORTANT NOTE: Before discarding the packaging ensure you have the
cover, M4 washers (2), M5 spring washer, M4 x12 screw and M4 Nylock nut.
Tools Required
1. Philips Screwdriver
2. Needlenose Pliers or M4 Socket Wrench
3. Drill with M5 drillbit
4. Pen or stylus
IMPORTANT NOTE: Before installation, ensure you have a clean flat
surface to work on. Disconnect the luminaire from the mains, and remove
the lamp module. Do not attempt to install the kit if the lamp module is
installed. The Pacific Lamp Module Cover is for fitting to the following lamp
modules only:
19PACLM1
19PACLM6
Pacific Lamp Module Cover Kit Installation Instructions
© 2004 Selecon New Zealand Limited All Rights Reserved
19PACLMCOV
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Selecon Pacific 19PACLMCOV
Summary of Contents for Selecon Pacific 19PACLMCOV
- Page 1 Do not attempt to install the kit if the lamp module is installed. The Pacific Lamp Module Cover is for fitting to the following lamp modules only: 19PACLM1 19PACLM6 Pacific Lamp Module Cover Kit Installation Instructions © 2004 Selecon New Zealand Limited All Rights Reserved...
- Page 2 Put the 2 x M4 washers, then the M4 spring washer over the end of the screw protruding through the underside of the lamp module handle. Pacific Lamp Module Cover Kit Installation Instructions © 2004 Selecon New Zealand Limited All Rights Reserved...
Need help?
Do you have a question about the Pacific 19PACLMCOV and is the answer not in the manual?
Questions and answers