Table of Contents
Advertisement
3．Installing/Removing the Bezel to the Server
Take the steps below to install the bezel to the server.
●Read the sections "Safety Precautions" and "Handling precautions" in the User's Guide of the
server in which you are going to install the bezel to install or remove the bezel safely and
properly.
Note: The outer dimension of the server is as follows after the bezel is installed.
175.0 mm (Width) × 492.0 mm (Depth) × 367.0 mm (Height) (Projection excluded)
1. Pull the front bezel as shown in figure below, then remove the front bezel.
2. Install the front bezel as shown in figure below.
Insert the three hinges of front bezel into the
holes of server
3. Stick the nameplate on the bezel shown by the slant lines in the figure below.
①
Nameplate
4
Front Bezel
①
②
②
①
Advertisement
Table of Contents
