Advertisement
H I
(1)
T
3
3
S
6
7
Insert the minifix ⑥ (nuts) with the cross
arrow mark facing downward and aim to
panel R and S 's lower thru holes. (As shown)
Insert the PVC dowels ⑦ to end of the
panels R to S. Using hammer to gently tap
them in.
Place panels R and S on each side of panel T
as shown.
Then tighten screw ③ to panels R and S 's
upper thru holes to fix them onto panel T.
(3)
U
T
Flip drawer with bottom side up, place panel
U onto panels R, S and T and insert panel U
to groove of panel Q.
Assembly Of Drawer : 1 DRAWER
3
3
R
DRAWER Q
6
7
Q
S
Hodedah
www.hodedah.com
support@hodedah.com
(2)
Insert, push down and tighten mini fix screw ⑥ , to the
non-thru hole as shown, 2pcs.
Inserting panels R and S 's lower PVC dowels onto the
upper non-thru holes at panel Q.
Then, tighten mini fix ⑥(nuts) clockwise to lock the mini fix
up for tightening panel R and S to panel Q. Cover 2 mini
fix caps provided by pushing the cover 's stem onto the
hole of mini fix nut on lower side of panel R and S.
(4)
4
Then nail the nails ⑩ provided with hammer on the
border of panel U as shown.The gap between 2 nails
should be about 100mm.
After that, place drawer slides B ⑭ with the small white
roller facing outward and with other end tip touching
panel Q onto each bottom side (angle) edge of panels R
and S.
Then tighten 2 screws ④ on each drawer slide B ⑭ (as
shown).
(5)
R
S
6
Q
6
4
14
4
U
4
10
T
S
COMPLETED
8
Advertisement
