Table of Contents
Advertisement
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem
CD OPERATION
"No disc" is displayed.
RADIO RECEPTION
Radio reception is poor.
GENERAL
The system does not react when buttons
are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
The timer is not working.
The Clock/Timer setting is erased.
18
pg 001-018_MCM285-77_Eng
Solution
– Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens
has cleared.
– Replace or clean the disc, see "Maintenance".
– Use a finalised CD-RW, CD-R or MP3 CD.
– Increase the distance between the Micro HiFi
System and your TV or VCR.
– Remove and reconnect the AC power plug and
switch on the system again.
– Adjust the volume.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
– Check the speaker connections and location.
– Reduce the distance between the remote control
and the system.
– Insert the batteries with their polarities
(+/– signs) aligned as indicated.
– Replace the batteries.
– Point the remote control directly toward
IR sensor on the front of the system.
– Set the clock correctly.
– Press TIMER in standby mode to switch on the
timer.
– If a recording is in progress, stop the recording.
– Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
18
2008.5.7, 16:55
Advertisement
Table of Contents
