Clock/Timer; Clock Setting; Timer Setting; Sleep Timer Setting - Philips MCD196/98 User Manual

STANDBY - ON
DISPLAY/CLOCK SET
DBB
DSC
AUX

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

●
The system can be used as an alarm clock,
whereby DISC or TUNER is switched on at a set
time (one time operation). The clock time needs
to be set first before the timer can be used.
1
In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Pressí/ë on the front panel or on the
remote control to set the hours and press
SLEEP/TIMER to confirm.
➜
The minute digits flash on the display panel.
3
Pressí/ë on the front panel or on the
remote control to set the minutes and press
SLEEP/TIMER to confirm.
4
In standby mode, press TIMER on the remote
control to activate or deactivate the timer.
➜
Display shows
if deactivated.
M I C R O T H E A T R E M C D 1 9 6
- +
VOLUME
iR
if activated, and disappears
SOURCE
PRESET
TUNING

Sleep timer setting

The sleep timer enables the system to switch off
by itself after a set period of time.
1
In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in
minutes):
SLEEP OFF ™ SLEEP 90 ™ SLEEP 80 ™
SLEEP 70 ™ SLEEP 60 ™ SLEEP 50 ™
SLEEP 40 ™ SLEEP 30 ™ SLEEP 20 ™
SLEEP 10™ SLEEP OFF
2
When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press STANDBY ON y
(or y on the remote).

Clock/Timer

CLOCK
33