Table of Contents
Advertisement
Viewing clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(DISC or TUNER for example), or Eco-
power standby mode
●
Press briefly CLOCK on the remote.
➜
The clock is displayed for a few seconds.
➜
If the clock has not been set, "--:--" is
displayed for a few seconds.
Setting clock
1
In standby or any source mode, press and hold
CLOCK on the remote.
➜
The clock digits flash on the display panel.
➜
If the clock has not been set, "--:--" flashes
2
Press ¡ / ™ on the set repeatedly to set the
hour.
3
Press à / á on the set repeatedly to set the
minute.
4
Press and hold MODE on the front panel for
more than 5 seconds to toggle between 12-hour
and 24-hour display.
5
Press CLOCK again to store the setting.
➜
The clock starts working.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 25 seconds.
– To exit clock setting without storing, press STOP
on the system to exit.
Setting wake-up timer
The system can switch on to DISC or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
– To set a new timer, you need to
deactivate the previously set timer.
1
In standby mode, press and hold SLEEP/
TIMER on the remote for more than five
seconds to enter timer setting mode.
➜
The source and timer digits will be lighted on
the display panel.
➜
" NO TIMER " will be displayed briefly if
wake-up timer is not set.
2
Press DISC or TUNER to select the desired
source.
●
Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3
Press ¡ / ™ repeatedly to set the hour.
4
Press à / á repeatedly to set the minute.
5
Press SLEEP/TIMER to store the time.
●
At the preset time, the selected source will play.
To deactivate the wake-up timer
●
In standby mode, press and hold SLEEP/
TIMER until "TIMER OFF" is displayed on the
panel.
Notes:
– The system will exit timer setting mode if no
button is pressed within 25 seconds.
– Display shows
if activated, and disappears if
deactivated.
Setting sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF
2
Press SLEEP/TIMER until you reach the
desired length of time.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press the STANDBY ON y
button.
Clock/Timer
33
Hide quick links:
Advertisement
Table of Contents
