T&S 002824-40 Installation And Maintenance Instructions Manual

Base faucet assembly for pre-rinse units
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Limited One Year Warranty
T&S warrants to the original purchaser (other
than for purposes of resale) that such product is
free from defects in material and workmanship for
a period of one (1) year from the date of purchase.
During this one-year warranty period, if the product
is found to be defective, T&S shall, at its options,
repair and/or replace it. To obtain warranty ser-
vice, products must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other trans-
portation charges of the product to T&S and the
return of repaired or replaced product to the pur-
chaser are the responsibility of the purchaser.
Repair and/or replacement shall be made within a
reasonable time after receipt by T&S of the re-
turned product. This warranty does not cover Items
which have received secondary finishing or have
been altered or modified after purchase, or for de-
fects caused by physical abuse to or misuse of
the product, or shipment of the products.
Any express warranty not provided herein, and
any remedy for Breach of Contract which might
arise, is hereby excluded and disclaimed. Any
implied warranties of merchantability or fitness for
a particular purpose are limited to one year in du-
ration. Under no circumstances shall T&S be li-
able for loss of use or any special consequential
costs, expenses or damages.
Some states do not allow limitations on how
long and implied warranty lasts or the exclusion
or limitation of incidental or consequential dam-
ages, so the above limitations or exclusions may
not apply to you. Specific rights under this war-
ranty and other rights vary from state to state.
P/N: 098-005241-45 Rev 4
Date: 10-23-02
Drawn: TEH
Checked: MVW 11-26-02
Approved: MVW 11-26-02
Installation and
Maintenance
Instructions
BASE FAUCET ASSEMBLY
002824-40 - for Pre-Rinse
Units
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 002824-40 and is the answer not in the manual?

Questions and answers

Summary of Contents for T&S 002824-40

  • Page 1 Under no circumstances shall T&S be li- 002824-40 - for Pre-Rinse able for loss of use or any special consequential costs, expenses or damages.
  • Page 2: Exploded View

    Exploded View 006090-45 006089-45 002898-45 Some items are listed for instructional purposes and may not be sold as separate parts.
  • Page 3 Part Number Guide Base Faucet Assembly - 002824-40 Body, Faucet Asm, Spdl LH - Eterna w/ Spring Checks 002711-40 Asm, Spdl RH - Eterna w/ Spring Checks 002712-40 Washer, Body 002290-45 Locknut, Shank 000965-45 Tailpiece 001592-20 Nut, Nipple Coupling 000958-20...
  • Page 4: General Instructions

    General Instructions Faucet Installation: 3. Remove no.5 and no.4 from no.1. 1. Shut off water supply and drain 4. Place no.1 through hole in sink, lines. Drill a hole approximately align hot and cold sides parallel to 1-1/4” diameter in countertop where sink line you are installing no.1.
  • Page 5: Instrucciones Generales

    Instrucciones Generales Instalación de la canilla: 3. Quite las parte No.5 y No.4 de la parte No.1. 1. Cierre la fuente principal de agua y desagüe las tuberias. Con el taladro 4. Coloque la parte No.1 a través del perfore un hueco aproximadamente de hueco en el mostrador, aline la llave 1-1/4”...
  • Page 6: Instructions Générales

    Instructions Générales Installation du Robinet: 4. Mettre le Nº.1 dans le trou de l’évier, aligner les côtés chauds et 1. Couper l’alimentation d’eau et froids parallèles au tuyau du robinet. purger la tuyauterie. Percer un trou d’environ 1-1/4” de diamètre dans le support ou vous installer le Nº.1.
  • Page 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Wasserhahninstallation: 4. Nr. 1 durch das Loch im Waschbecken führen, Warm- und 1. Wasser abstellen und Kaltwasser- armatur parallel zur Wasserleitungen entleeren. In die Waschbeckenkante anordnen. Abdeckplatte des Waschtisches ein ungefähr 1-1/4” großes Loch bohren, in das Nr. 1 installiert wird. 2.
  • Page 8 RELATED T&S BRASS PRODUCT LINE B-20K Parts Kit B-0111 B-0220-LN Pre-Rinse Deck Mixing Faucet T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’...

Table of Contents