Advertisement
9. Inspect and confirm that the batteries in the electronics
enclosure are properly inserted, connected to the
battery terminal connections and secured in the battery
holder compartment. (In the case of 9V cells, make
sure the wires point toward you as you secure them in
place and the battery connectors should point toward
the circuit board).
10. Perform an Install function with a valid TRACcess
eKEY. Refer to the TRACcess eKEY user instructions
for step by step operation.
11. Test the lock operation using the TRACcess eKEY.
Refer to the TRACcess eKEY user instructions for step
by step operation. Test the lock first with the door open
and then with the door shut to ensure the lock strike
catches the door frame.
12. When you test the lock with your key, the LED at the
top of the interface will flash green, indicating the door
may be opened. If the device is a TRAC-Station BT
programmed for TIMED mode, the light will remain
flashing for a preprogrammed period of time, during
which the door may be opened. If the device is a
TRAC-Station BT programmed for LATCHED mode,
once the light flashes green, the door may be opened
until the lock is reset. If it is programmed for LATCHED
mode, be sure to reset the lock.
13. Once you have tested the lock, place the lid on the
back of the electronics enclosure and position the logo
directly over the battery pack. Insert the provided six
#4 × 1/2 in. (13 mm) flathead screws into the predrilled
holes. Hand-tighten the upper right corner screw and
continue hand-tightening the remaining screws in a
clockwise order. Do not overtighten the screws, as
doing so may damage the electronics enclosure and
Figure 2. TRAC-Station BT assembly as example
Exterior WTI
Interface
Plate
Lockset
2-wire plug
Supra: 800-547-0252 • www.suprasystems.com
prevent the lid from being securely fastened.
14. Record the device serial number and location.
Battery removal/disposal
Replacing the interface is a good time to service the
batteries. The batteries should be periodically replaced.
This product contains either three 9-volt batteries (TRAC-
Lock BT) or eight AA batteries (TRAC-Station BT). To
remove the batteries, do the following:
1.
Remove the lid from the electronics enclosure.
2.
Pull the batteries out of the slots.
For proper recycling, dispose of all batteries as required by
local ordinances or regulations.
FCC
The device, Assy, Bezel, WTI, part number 10102917G1,
complies with part 15 of the FCC rules. Operation is subject to
the following conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
2002/96/EC (WEEE directive). Products marked with this
symbol cannot be disposed of as unsorted municipal waste in
the European Union. For proper recycling, return this product
to your local supplier upon the purchase of equivalent new
equipment, or dispose of it at designated collection points.
Interior
Electronics
Mounting
Enclosure
Plate
4-wire
plug
Electronics
Enclosure Lid
Advertisement
