Table of Contents
Advertisement
NOTE: This operations section was designed to give instructions on the basic operations of this
planer. However, it is in no way comprehensive of every planer operation. It is strongly
recommended that you read books, trade magazines, or get formal training to maximize the
potential of your planer while minimizing the risks.
NOTE: This planer is designed to process wood ONLY.
WARNING! Make sure the switch is in the "OFF" position before connecting cord into
socket. Do not touch the plug's prongs when unplugging or plugging.
WARNING! In the case of a power outage (such as a breaker or fuse trip), always turn the
switch to the "OFF" position until the power is restored.
1. The on/off switch (A) Fig. 11 is on the front of the planer motor. To turn the machine "ON",
The machine is fitted with a No Volt Release (NVR) safety switch. The NVR switch can only
be activated if the machine is connected to mains power. During operation, any disruption to
move the switch up to the "ON" position.
the mains power supply will see the this NVR switch release, preventing the machine
2. To turn the machine "OFF", move the switch (A) down to the "OFF" position.
restarting automatically. The user will need to physically re-start the unit after the cutterhead
has come to a complete stop.
TURNING SWITCH IN THE "OFF" POSITION
The jointer is started on by pressing the green ON button. In regular operation, the machine
IMPORTANT: When the machine is not in use, the switch should be on the "OFF" position
is switched off, by pressing the RED stop button.
to prevent unauthorized use. To lock the machine, pull the switch key (K) out of the switch
(Fig. 12). Without the switch key, the switch will not work. However, if the switch key be
removed while running the planer, the machine can be moved to "OFF" position, but
cannot be restarted without the switch key.
FIG 11
OPERATIONS
A
K
FIG 12
13
Advertisement
Table of Contents
