Sunrise Medical Quickie Installation Instructions

Please read these instructions carefully before beginning the installation. Failure to understand and
follow installation instructions may result in injury to installer and/or end user and may void the warranty.
If you have any questions call Sunrise Medical Technical support at 800-333-4000.
A. Preparing for installation:
1. Remove the seat cushion. Remove the 4 screws (A) holding the seat to the adapter plates or module. Note mounting position on the
adapter plates or module. (Fig 1) Set seat and hardware aside.
2. Remove adapter plates from the module (if required). Note mounting positon, save hardware. (Fig 1)
3. Flip the seat frame interface back. Disconnect module harness from base and then remove the 6 screws (B) holding the module to the
seat frame interface. Note mounting position, save hardware. (Fig 2)
Sedeo Ergo
Seat
A
Adapter
Plates*
©2017 Sunrise Medical (US) LLC
1
Module
*Sedeo Ergo only
HARNESS ROUTING
Module
Seat Frame
Interface
B
Recline
Seat
TILT/LIFT COMBO
Back
cut-out
ASAP
Seat
246792 Rev. A Pg. 1 of 4
2