Table of Contents
Advertisement
Preparations
●
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of + / - speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
– Position FM antenna as far as possible from the
speaker wires to avoid interference.
D
Optional connection
The optional equipment and connecting cords
are not supplied. Refer to the operating
instructions of the connected equipment for
details.
Connecting a USB device or memory
card
By connecting a USB mass storage device
(including USB flash memory, USB flash players
or memory cards) to the Hi-Fi system, you can
enjoy the device's stored music through the
powerful speakers of Hi-Fi system.
●
Insert the USB device's USB plug into the
socket on the set.
OR
for the devices with USB cables:
1
Insert one plug of the USB cable (not supplied)
to the
socket on the set.
2
Insert the other plug of the USB cable to the
USB output terminal of the USB device.
OR
for the memory card:
1
Insert the memory card into a card reader (not
supplied).
2
Use a USB cable (not supplied) to connect the
card reader into the
Connecting a non-USB device
Use a cinch cable to connect AUX to the
analogue audio out terminals of an external
equipment (TV, VCR, Laser Disc player, DVD
8
socket on the set.
player or CD Recorder).
Note:
– If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX left terminal. Alternatively, you can use a
"single to double" cinch cable (the output sound
still remain mono).
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example CD, FM).
3
Then select the desired function (for example
ÉÅ, S, T).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully inser t the
battery compartment back to the original
position.
1
2
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
3
Advertisement
Table of Contents
Troubleshooting
