Installation Steps - Agilent Technologies 75000 Series B Configuration Manual

Installation Steps

Note
If you ordered the DC Power Option (option 008) and you want to change the factory
switch settings, you should change them before doing the procedures in this chapter. The
factory switch settings are 0mA (no trickle charging of external battery) and non-latched
power-down operation. Refer to Appendix D of the Mainframe User's Manual for details.
1-2 Inst alling the Syst em
Step 1: Set Up Mainframe f or AC Pow er (Page 1-3)
Step 2: Select Int ernal IBASIC or Ext ernal Controller (Page 1-4)
Step 3: Rack Mount the Mainframe (Optional) (Page 1-5)
Step 4: Det ermine Inst rument Configurat ions (Page 1-6)
Step 5: Set Plug-In Module Logical Addresses (Page 1-9)
Step 6: Install Plug-In Modules (Page 1-13)
Step 7: Connect Bus Cables (Page 1-14)
Step 8: Connect Interface Cables (Page 1-16)
Step 9: Apply AC Pow er (Page 1-18)
Step 10: Connect Ext ernal DC Pow er (Optional) (Page 1-19)
Step 11: Dow nload Device Drivers (Page 1-20)
Step 12: Verify Operation (Page 1-21)
Wire Terminal Blocks (see individual plug-in module manuals)