Agilent Technologies 75000 Series B Configuration Manual page 77

cable part numbers, B-1
cable, connecting, 1-17
custom cable, B-1
protocol settings, 1-17
S
Scanning DVM or DMM
See Scanning multimeter
Scanning multimeter:, 1-11
built-in, 1-11
connecting cables, 1-14
example, 1-11
example (built-in), 1-11
instrument, configuration, 1-7
multiplexers in, 1-7
Scanning voltmeter
See scanning multimeter
Scanning:
channels, 1-7
maximum rates, 1-15
measurements, 1-8
Schematic, RS-232 cable, B-1
Secondary address, GPIB, 1-8
Secondary address:
GPIB, 1-6 - 1-7
Select instrument:
from an instrument menu, 2-16
from main menu, 2-15
Select internal or external controller, 1-4
Selecting IBASIC controller, 1-4
Sending SCPI commands, 2-2
BASIC/IBASIC, 2-13
C, 2-11
C/C+ + , 2-6
Terminal, 2-15
Visual BASIC, 2-3
Sending SCPI commands and receiving data
C/C+ + , 2-6
Visual BASIC, 2-2
Set up mainframe for AC power, 1-3
Setting:
line voltage, 1-3
logical address, 1-10
mainframe interrupt bypass switches, B-5
plug-in module logical addresses, 1-9
Shock hazard warnings, vii
SICL
Agilent, 2-2, 2-5
using C/C+ + , 2-5
using visual basic, 2-2
Single module instrument:
configuring, 1-6
example, 1-10
Softkeys, using, C-10
Standalone instruments, configuring, 1-6
Start-Up errors, A-2
Start-Up errors and messages, A-2
Starting the application code, C-11
Static electricity caution, vii
Step 1: set up mainframe for AC power, 1-3
Step 2: select internal or external controller, 1-4
Step 3: rack mount the mainframe, 1-5
Step 4: determine instrument configurations, 1-6
Step 5: set plug-in module logical addresses, 1-9
Step 6: install plug-in modules, 1-13
Step 7: connect bus cables, 1-14
Step 8: connect interface cables, 1-16
Step 9: apply AC power, 1-18
Step 10: connect external DC power, 1-19
Step 11: download device drivers, 1-20
Step 12: verify operation, 1-21
Step 12A: verify using the VERF_XXX program,
1-21
Step 12B: verifying using other than the
VERF_XXX program, 1-22
Steps to debug programs, C-1
Steps, automating the debugging steps, C-7
Steps, installation, 1-2
Subprogram, using the ©E13xx_errorsª, C-10
Supported C programs, 2-10
Switch
See also multiplexer
Switch modules allowed in switchbox, 1-8
Switchbox:
configuring, 1-8
example, 1-12
logical addresses, 1-12
modules allowed, 1-8
multiple module, 1-8
single module, 1-8
Switches, setting the mainframe interrupt bypass,
B-5
System error message listing, A-4
System errors, A-3
System errors and messages, A-3
System time
checking, 1-23
setting, 1-23
T
Terminal block, 1-1
Terminal, connecting the, 2-15
Index 5