Table of Contents
Advertisement
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby DISC, USB or TUNER is switched on at a
set time (one time operation). The clock time
needs to be set first before the timer can be used.
1
In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜
"SELECT SOURCE" is displayed briefly.
2
Press DISC, USB or TUNER to select your
desired source and press SLEEP/TIMER to
confirm.
➜
"SET ON TIME" is displayed briefly. Then, the
hour digits flash on the display screen.
●
Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
USB – connect a suitable USB device.
TUNER – tune to the desired radio station.
3
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the hours and press
SLEEP/TIMER to confirm.
➜
The minute digits flash on the display panel.
4
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the minutes and press
SLEEP/TIMER to confirm.
➜
The timer is now set and activated.
5
In standby mode, press SLEEP/TIMER on the
remote control to activate or deactivate the
timer.
➜
Display shows
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in minutes):
OFF ™ SLEEP 90 ™ SLP 80 ™ SLEEP 70 ™
SLEEP 60 ™ SLEEP 50 ™ SLEEP 40 ™
SLEEP 30 ™ SLEEP 20 ™ SLEEP 10™ OFF
➜
"SLEEP XX" or "OFF" is displayed. "XX"
denotes the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press ECO POWER/STANDBY
ON y (or y on the remote).
Clock/Timer
2;
if activated, and disappears
35
Hide quick links:
Advertisement
Table of Contents
