Prepare The Remote Control; Set Clock; Turn On - Philips MCM3000/12 User Manual

Prepare the remote control

Caution
• Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
•
Risk of decreased battery life! Never mix
different brands or types of batteries.
• Risk of product damage! When the remote
control is not used for long periods, remove
the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
b

Set clock

1
In standby mode, press and hold
CLOCK/DISPLAY on the remote control
to activate the clock setting mode.
» The hour digits are displayed and begin
to blink.
a
c
2
Press / ( /
3
Press CLOCK/DISPLAY.
»
The minute digits are displayed and
begin to blink.
4
Press / ( /
5
Press CLOCK/DISPLAY to confirm.
Note
•
If no button is pressed in 15 minutes, the
system exits clock setting mode automatically.

Turn on

Press to turn on.
»
The unit switches to the last selected
source.
Switch to standby mode
Press again to switch the unit to standby
mode.
»
The clock (if set) appears on the
display panel.
Switch to ECO standby mode:
Press and hold for 3 seconds.
»
ECO STANDBY is displayed for 3
seconds and then disappeared.
Note
•
In standby mode, if there is no operation for
15 minutes, the unit switches to Eco Power
Standby mode automatically.
Switch between standby mode and ECO
standby mode:
Press and hold for 3 seconds.
) to set the hour.
) to set the minute.
EN 11