Table of Contents
Advertisement
Prepare the remote control
Caution
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Power on
Press .
» MCM2300 switches to the last selected
source.
Switch to standby mode
again to switch MCM2300 to standby
Press
mode.
» The clock (if set) is displayed on the panel.
•
In standby mode, press
between working mode and standby
mode.
Note
•
MCM2300 switches to Standby mode after 15 minutes
inactive.
8
EN
to switch
Switch to ECO power standby mode
Press and hold
for more than two seconds.
» The red ECO power standby indicator
turns on.
•
In Eco power standby mode, press
switch between working mode and ECO
power standby mode.
Note
•
MCM2300 switches to ECO power Standby mode
after 15 minutes in standby mode.
Switch between standby mode and ECO
power standby mode:
•
Press and hold
seconds.
Set the clock
1
In standby mode, press and hold CLOCK
for more than two seconds to enter the
clock setting mode.
» [24H] or [12H] is displayed.
2
Press
/
to select 24H or 12H hour
format, and then press CLOCK.
» The hour digits begin to blink.
3
Press
/
to set the hour, and then
press CLOCK.
» The minute digits begin to blink.
4
Press
/
to set the minute, and then
press CLOCK.
» The set clock is displayed.
Note
•
To view clock information in working mode, press
CLOCK.
•
If no button is pressed in 90 seconds during setting,
MCM2300 exits clock setting without saving earlier
operations.
to
for more tha@n two
Advertisement
Table of Contents
