Installing The Harness - Foppapedretti RE-KLINO Manual

INSTALLING AND REMOVING THE 5-POINT HARNESS
REMOVING THE 5-POINT HARNESS
1. Completely loosen the car seat's 5-point belt, pressing the strap adjustment button and
pulling the chest belts at the same time, from the bottom under the protective chest padding.
Notes! Do not pull the straps by the protective chest padding (4-A).
2. Pull the ends of the chest belts out of the belt-tension bracket. Pull the belt height
adjustment tension device and pull the end of the chest padding fastening belt (4-B) out of
the metal bar.
3. Remove the chest belts from the front of the car seat and the side protections (4-C).
4. Adjust the seat in the vertical position and release the bottom fabric fastening clip from
both sides of the seat (4-D) & (4-E).
5. Remove the seat lining, lift up the internal protective polyurethane padding. Find the
metal hip belt fastening ring. Lift the metal ring, if necessary, by pushing the buckle through
the hole located under the seat, to turn it and pull it out of the locking hole. Repeat on the
second slot. Pull the hip belt out of the internal side of the seat. Repeat this operation to
remove the other side of the hip belt (4-F).
6. Recline the seat as far as possible, find the metal buckle locking ring, turn it and lift the
buckle belt from the inside of the seat upwards (4-G) & (4-H).

INSTALLING THE HARNESS

Repeat the steps for "REMOVING THE 5-POINT HARNESS" in reverse order to put the
5-point harness back in.
IMPORTANT: Ensure it is installed correctly, ensure that none of the belts are twisted. Ensure
that the metal rings on the ends of the hip belt and the buckle belt are inserted correctly and
locked in their slots. Ensure that the ends of the chest belts are attached correctly to the belt-
tension bracket. In case of doubt, contact the manufacturer.
INSTALLING AND REMOVING THE LINING
REMOVING THE FABRIC LINING
Headrest
1. Adjust the headrest of the car seat in its highest position (5-A).
2. Grasp the elastic edge of the lining behind the headrest and remove the cover by pulling
frontwards (5-B).
Do not remove the styrofoam protection.
Seat fabric
1. Unhook the 6 clips from the frame (5-C).
2. Take the fabric off (5-D)
23
RE-KLINO