Fujitsu PRIMERGY TX2550 M4 Operating Manual page 54

Hardware installation
Figure 5: Connector panel
1 Serial connector (optional)*
2 Shared LAN connector
3 LAN connector
4 2 USB connectors (USB 3.0) 8* Dedicated slot for OCP modules
* When using an OCP module, the standard PCIe x16 slot is not usable.
The corresponding indicators are explained in section
I
Some of the devices connected require special software (e.g. drivers)
(see documentation for the connected device).
I
The LAN connectors on the OCP modules are numbered in ascending
order from right to left beginning with "0". The rightmost connector (LAN
0) is the shared LAN connector respectively.
Ê Connect the devices to the server.
54
5 2 USB connectors (USB 3.0)
6 Video connector (VGA)
7 Management LAN connector (for
iRMC S5 server management
function)
Operating Manual
"Server rear" on page
TX2550 M4
67.