Key Definitions; How To Use - Petainer IS-PET998DRU-1 Training Manual

Key Definitions

1. Antenna: Transmits the signal from the Transmitter to the Receiver Collar.
2. Led light: This light will be on when pressing the LED light button.
3. LED Indicator: This light will flash when the "Y" button is pressed. The light
will be activate when charging as well.
4. LCD Screen:
Static mode: With this mode selected, pressing the "Y" button will cause the
receiver to emit shock.
Vibration mode: With this mode selected, pressing the "Y" button will cause
the receiver to vibrate.
Beep Mode: With this mode selected, pressing the "Y" button will cause the
receiver to emit a beep sound.
Light Mode: With this mode selected, pressing the "Y" button will cause the
LED light on the receiver to flash red once every second. Its primary purpose
is to help locate your pet.
5. U p/Down Button
1. Antenna
6. Led Light Button
2. LED Light
7. Channel Button
3. LED Indicator
8. Launch Button
4. LCD Screen
9. Mode Button
1-100 Level
10. Transmitter Charging
Static Shock Mode
Jack
Vibration Mode
11. Contact Points with
Beep Mode Silicon Covers
12. Button
Light Mode
13. Receiver Charging
Channel 1
Jack
Channel 2
14. Rubber Cover
Low Battery Indicator
-5-
Channel 1: Indicates the selection of the first collar receiver.
Channel 2: Indicates the selection of the second collar receiver.
5. Up/down buttons: Selects intensity level for Vibration and Static Shock.
6. Led light button: When pressing the LED light button, the LED light on the
transmitter will be on.
7. Channel button: Pressing this button will swap between the first and second
collar receiver.
8. Launch button: Sends the signal from transmitter to receiver, resulting in
stimulation, beep or light, depending on your mode selection.
9. Mode button: Press this button to switch between modes. There are 4
modes: Static, Vibration, Beep and light mode.
10. Transmitter Charging Jack : Insert charging connector into charging hole to
charge the Transmitter.
11. Contact Points: Helps deliver safe static correction. Do not remove silicone
covers as it helps protect dog's neck from irritation due to the stainless steel
contacts. Static shock can still be felt through silicone covers.
12. button : 1)Turn ON/OFF the receiver collar.
2) Pair the transmitter and receiver.
13. Receiver Charging Jack : Insert charging connector into charging jack to
charge the receiver.
14. Rubber Cover: Seals charging jack to keep dust and water from entering. If
not sealed, then the item will not be waterproof.

HOW TO USE

Note: Please charge before using the product! Please ensure you're putting
the correct side of the cable into the USB charger port as the connector is not
the same size on both ends.
-6-