Table of Contents
Advertisement
2. If your device has I/O, connect the sensors to the Sure Cross devices. If your device does not have I/O, skip this step.
3. Refer to the wiring diagrams to apply power to all devices.
•
For two LED models, the Gateway's LED 1 is solid green and the Node's LED 2 flashes red to indicate there is no radio link to
the Gateway.
•
For one LED models, the Gateway's LED is solid green and the Node's LED flashes red to indicate there is no radio link to the
Gateway.
4. Form the wireless network by binding the Nodes to the Gateway. If the binding instructions are not included in the datasheet,
refer to the product manual for binding instructions.
5. Observe the LED behavior to verify the devices are communicating with each other.
•
For two LED models, the Gateway's LED 1 is solid green and the Node's LED 1 flashes green to indicate it is communicating
with the Gateway.
•
For one LED models, the Gateway's LED is solid green and the Node's LED flashes green to indicate it is communicating with
the Gateway.
6. Configure any I/O points to use the sensors connected to the Sure Cross devices.
7. Conduct a site survey between the Gateway and Nodes. If the site survey instructions are not included in this datasheet, refer
to the product manual for detailed site survey instructions.
8. Install your wireless sensor network components. If installation instructions are not included in this datasheet, refer to the
product manual for detailed installation instructions.
For additional information, including installation and setup, weatherproofing, device menu maps, troubleshooting, and a list of
accessories, refer to one of the following product manuals.
®
•
Sure Cross
Wireless I/O Network Instruction Manual:
•
Web Configurator Instruction Manual (used with "Pro" and DX83 models):
•
Host Controller Systems Instruction Manual:
Configure the DIP Switches
Before changing DIP switch positions, disconnect the power. For devices with batteries integrated into the housing, remove the
battery(ies) for at least one minute. DIP switch changes are not recognized until after power is cycled to the device.
Accessing the DIP Switches of a Single-Chamber Metal Housing
The DIP switches are located behind the rotary dials.
To access the DIP switches, follow these steps:
1. Unscrew and remove the top of the DX99 metal housing. The top section is the section with the glass window.
2. Pull the radio cover section off the bracket assembly. Two pins hold the radio cover to the bracket assembly.
3. Gently unplug the ribbon cable from the back of the radio cover.
4. Remove the black cover plate from the bottom of the device's cover.
The DIP switches are located behind the rotary dials.
After making the necessary changes to the DIP switches, place the black cover plate back into position and
gently push into place. Plug the ribbon cable in after verifying that the blocked hole lines up with the
missing pin. Mount the cover back onto the bracket assembly.
DIP Switch Settings
Device Settings
Rotary switch address mode
Extended address mode
Temp °Fahrenheit
Temp °Celsius
High resolution (0.1 degree)**
Low resolution (1 degree)
Discrete sinking inputs
Discrete sourcing inputs
2
132607
132114
1
2
3
OFF*
ON
OFF*
ON
OFF*
ON
www.bannerengineering.com - Tel: +1-763-544-3164
®
Sure Cross
DX99 FlexPower Thermocouple Node (Metal Housing)
134421
Switches
4
5
6
OFF*
ON
7
8
P/N 142681 Rev. O
Advertisement
Table of Contents
