Joni MaxiMix QuickChill Operating Manual page 28

open, an error code will be shown. If the kettle is fitted with SlowMix, the stirrer can however rotate slowly
when the lid is open and the kettle is tilted.The fan in the bottom of the kettle allows the stirrer motor to
be cooled. It ventilates the air when the stirrer is operating or the jacket temperature exceeds 40 ºC.
Fitting a stirrer/cleaning tool
Before the stirrer is started, it is important that the tool is mounted correctly in the kettle. This procedure
is described below.
1) 1.Tilt the kettle bowl so that it is horizontal.
2) Push the tool in over the shaft of the stirrer.
Make sure that the bottom scraper on the stirrer is on the right-hand side and hangs down. The side
scraper should be on the left-hand side and point upwards.
Make sure that the brushes on the cleaning tool are pressed into place on the rails.
If necessary, place the tool on a height-adjustable trolley, which can be pushed in front of the kettle.
This minimises the need for lifting.
3) Tilt the kettle bowl so that it is vertical.
4) Attach the tool by tapping the lifting handle down to a horizontal position.
The stirrer is now ready for use.
After use, remove the tool by reversing the above procedure.
NOTICE!
With slow stirring in tough content, it can happen that the motor gets overloaded and comes up
with the Error E70.
When stirring in tough content, it's best to use program 2 or 4.
Operating the stirrer
The stirrer is controlled using the part of the panel shown in the following illustration.
27/69
Fig. 0-20 Tool is pulled out
we know what's cooking