DITEC FACIL Installation And Maintenance Manual page 13

OPERATING INSTRUCTIONS FOR SWING GATES AUTOMATION FACIL
RELEASE INSTRUCTIONS
In the event of a fault or a power failure, introduce the key, turn
it clockwise and fully open the hatch. Manually open the gate.
To lock the gate again, close the hatch, turn the key anti-
clockwise and remove the key.
Warning: the gate lock and release operations must be per-
formed with the motor idle. Do not enter within the operating
range of the leaf.
Note: (FACIL3H only) to turn off the automation the power sup-
ply and batteries (if present) must be disconnected.
Warning: when the hatch is closed but the key is still horizon-
tal, the release microswitch is open and all manoeuvres are
prevented.
GENERAL SAFETY WARNINGS
The following warnings are an integral and essential
part of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenance. These instruction
must be kept and forwarded to all possible future user of the
system.
This product must be used only for that which it has been ex-
pressly designed. Any other use is to be considered improper
and therefore dangerous. The manufacturer can not be held
responsible for possible damage caused by improper, incorrect
or unreasonable use. Avoid operating in the proximity of the
hinges or moving mechanical parts. Do not enter within the
operating range of the gate while it is moving.
Do not obstruct the motion of the motorised door or gate as
this may cause a dangerous situation. Do not allow children to
play or stay within the operating range of the motorised door
or gate. Keep remote controls or any other control devices out
of the reach of children, in order to avoid possible involuntary
activation of the motorised door or gate.
In the event of fault or malfunctioning of the product, turn off
the power supply switch, do not attempt to repair or intervene
directly and contact only qualified personnel.
Failure to comply with the above may cause a dangerous
situation.
All cleaning, maintenance or repair work must be carried out
by qualified personnel.
In order to guarantee that the system works efficiently and
correctly, it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the moto-
rised door or gate carried out by qualified personnel.
In particular, regular checks are recommended in order to
verify that the safety devices are operating correctly. All instal-
lation, maintenance and repair work must be documented and
made available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
1
ON
OFF
Installer:
2