Listen To Radio; Store Dab Radio Stations Automatically; Basic Operations; Use The Menu - Philips DTB297 User Manual

Dab+/fm ipod dual clock radio
Hide thumbs Also See for DTB297:
Table of Contents

Advertisement

5 Listen to radio

Note
For optimal reception, fully extend the antenna and
adjust its position, or connect an outdoor antenna.
This product does not support MW (medium wave)
radio reception.
You can program a maximum of 20 DAB radio stations
and 20 FM radio stations.
Check with local retailer or go to www.WorldDAB.org
for the applicable DAB radio frequencies in your area.
Refer to "Product information" > "RDS program types"
for more information about RDS radio stations.
Store DAB radio stations
automatically
If no DAB radio station is stored, this product
can search and store DAB radio stations
automatically.
1
Press SOURCE repeatedly to select the
DAB source.
» [FULL SCAN] (full scan) scrolls on the
display panel.
2
Press OK/
» This product automatically stores DAB
radio stations with sufficient signal
strength.
» After all available DAB radio stations
are stored, the first stored DAB radio
station is broadcast automatically.

Basic operations

Follow the instructions below for more
functions.
Tune to the next FM radio station with
sufficient signal strength at the lower/higher
frequency:
Press and hold TUNING +/-
auto search.
EN
12
to start auto installation.
/
to start
Tune to the FM radio station at a specific
frequency:
Press TUNING +/-
frequency digitals are displayed.
Program FM radio stations automatically:
Press SCAN/PROG/
programming.
Program DAB radio stations automatically:
Press SCAN/PROG/
scanning and programming.
Program radio stations manually:
1) Tune to a radio station.
2) Press and hold SCAN/PROG/
activate programming.
3) Press PRESET +/-
sequence number to the radio station.
4) Press OK/
to confirm.
5) Repeat steps 1-4 to program more radio
stations.
Tune to a preset radio station:
Press PRESET +/-
Switch the audio mode between [STEREO]
(stereo) and [MONO] (monophonic) for FM
radio:
Press OK/
repeatedly.
Display available information about the
current radio station:
Press MENU/INFO/SET TIME/

Use the menu

When you listen to radio, you can access the
menu for control options.
1
Press and hold MENU/INFO/SET TIME/
.
» FM mode: [SCAN] (scan) is displayed.
» DAB mode: [FULL SCAN] (full scan)
is displayed.
2
Press TUNING +/-
menu option, and then press OK/
confirm the option or enter the lower-level
menu.
/
repeatedly until the
to start auto
to start auto
to
/
to assign a
/
repeatedly.
repeatedly.
/
to select a
to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents