Table of Contents
Advertisement
The following steps show how to get DNS and Gateway settings of the current
network from the PC connected to the same network:
1 On your PC, click Start > Run
2 Type cmd and click OK
3 Type ipconfig/all
4 Write down the DNS and Gateway of the current connection.
On
1 Press
MENU
to enter the menu screen.
3
4
2 Use
or
and
2
3 Press
to continue.
Set DNS
1 Enter the DNS server you wrote down.
2 Press
OK
to confirm.
3 Press
OK
to skip Set DNS2.
Tip
If necessary, follow Steps 1 and 2 above to set a secondary DNS server in Set DNS2.
Set Gateway
1 Enter the Gateway you wrote down.
2 Press
OK
to confirm.
Set proxy
1 If you are using a proxy server to visit websites, enable Proxy and proceed with the proxy
setting as prompted, then press
2 Choose to apply the settings as prompted.
> Settings will change.
Connection to station could be lost appears.
74
2
to enter Settings followed by Network, then Wired.
OK
to confirm Otherwise, press
OK
to skip.
Network settings
Advertisement
Table of Contents
