Download Print this page

Warning Label - Hyundai J9F57 AC200 Manual

Kona, remote engine start - push start

Advertisement

10
Clean Cloth and 50/50 Mix of Isopropyl Alcohol (70%) and Water

Warning Label

A. Clean the left top surface of the Radiator Cover.
- Ensure the surface is completely dry.
B. Remove the Adhesive Liner from the Warning Label, then secure
the label to the Radiator Cover as shown.
N
O
T
E
Ensure the surface is completely dry before installing the Warning Label.
Ensure the label is aligned straight with the edge of the Radiator Cover
and without air bubbles under the label.
12
GO TO → Function Check
A. Perform the Function Check at the end of the Instructions.
N
O
T
E
Genuine Accessories
Ratchet, 10mm Deep Well Socket, Extension, and Torque
11
Wrench
Negative Battery
Cable
A. Reconnect the Negative (-) Battery Cable. Torque to:
5.0 ~ 6.0 N.m (0.5 ~ 0.6 kgf.m, 45 ~ 52 lb-in)
B. Reinstall the vehicle's Negative (-) Battery Terminal Cover, if applicable.
C. Make sure the Transportation Fuse is in the "ON" position.
N
D. Reinstall the weatherstrip at dash area to allow Driver's Door to
O
close properly.
T
E. Close the Hood, Tailgate and all Doors.
E
F. Test the LOCK / UNLOCK function using Smart Key Fob.
G. Enter the vehicle, holding a Smart Key, depress the Brake Pedal and
push the START button to start the engine.
H. Wait for 5 sec., and push the START button to stop the engine.
NOTE: If vehicle is not responding, carefully re-check all wiring
connections. If the vehicle is still not responding, follow the
Troubleshooting at the end of the instructions.
13
#2 Phillips Screwdriver
A. Reinstall all removed parts as follows:
- Install the Remote Start OBDII Connector to the Lower Dash Panel.
- Install the Lower Dash Panel ensuring the Lower Tab on the left hand
side bottom of panel is first tucked into the Kick Panel.
N
- Reinstall the Dash End Cap.
O
- Reinstall the Weatherstrip ensuring there are no kinks.
T
- Reinstall Fuse Panel Cover.
E
B. Place the Quick Reference Guide and the Owner's Guide into the Glove
Box.
C. Attach the Remote Start Fobs to each of the Factory Key Fob Rings.
Revision Date
01/02/2019
Negative Battery
Cover
Page 7 of 10

Advertisement

loading