Advertisement
6
Wire Cutters
Factory OBDII
Female Connector
Wire Ties (2)
A. Connect the corresponding Remote Start OBD II Connector to the OBD II Connector disconnected from Lower Dash Panel.
B. Lock connectors in place tightly using two (2) Wire Ties behind connector slots to prevent separation between factory OBDII and Remote Engine Start OBDII
N
connector as shown.
O
T
E
Caution! Do not damage the Lower Dash Panel, OBDII Connector or Electrical Connectors.
7
Wire Cutters
Fuse Box
Back Side
16-Pin CAN
Connector
A. Route the 16-Pin CAN Connector and Harness behind the Fuse Box.
B. Locate the factory 16-Pin Female CAN-Connector, found on the back side of the Fuse box, as shown above.
N
C. Disconnect the 16-Pin CAN Connector from the back side of the Fuse Box.
O
NOTE: The factory 16-Pin CAN Connector may be difficult to disconnect, make sure to fully press in the release tab before pulling out the connector.
T
D. Connect the corresponding Remote Start T-Harness Connector to the 16-Pin CAN Connector and Fuse Box (back side).
E
E. Using one (1) Wire Tie, secure the 16-Pin CAN Connector to Vehicle Harness as shown.
F. Trim excess Wire Tie material.
Ensure 16-Pin CAN Connector is fully seated in the Fuse Box.
Genuine Accessories
Slots
Wire Ties
Remote Start
OBDII Connector
Revision Date
01/02/2019
Wire Tie
Fuse Box
Back Side
16-Pin CAN
Connector
Page 5 of 10
Advertisement
